The cross-sectional area of all wires is $10^{-4} \ m^2$. What is the displacement of point $D$?

If the ratio of diameters,lengths,and Young's modulus of steel and copper wires shown in the figure are $p, q$ and $s$ respectively,then the corresponding ratio of increase in their lengths would be

$A$ steel and a brass wire, each of length $50 \,cm$ and cross-sectional area $0.005 \,cm^{2}$, hang from a ceiling and are $15 \,cm$ apart. Lower ends of the wires are attached to a light horizontal bar. $A$ suitable downward load is applied to the bar so that each of the wires extends in length by $0.1 \,cm$. At what distance from the steel wire must the load be applied (in $\,cm$)? [Young's modulus of steel is $2 \times 10^{12} \,dynes/cm^{2}$ and that of brass is $1 \times 10^{12} \,dynes/cm^{2}$]

$A$ steel rod with a circular cross-section of diameter $1 \ cm$ and another steel rod with a square cross-section of side $1 \ cm$ have equal mass. If the two rods are subjected to the same tension, the ratio of the elongations of the two rods is

The speed of a transverse wave passing through a string of length $50 \; cm$ and mass $10 \; g$ is $60 \; ms^{-1}$. The area of cross-section of the wire is $2.0 \; mm^2$ and its Young's modulus is $1.2 \times 10^{11} \; Nm^{-2}$. The extension of the wire over its natural length due to its tension will be $x \times 10^{-5} \; m$. The value of $x$ is $...$

Which of the following curves represents the correct distribution of elongation $(y)$ along a heavy rod under its own weight? ($L$ = length of rod, $x$ = distance of a point from the lower end).