$A$ spring-block system is placed on a rough horizontal floor. The block is pulled towards the right to give the spring some elongation and then released.

$A$ block $B$ is placed on block $A$. The mass of block $B$ is less than the mass of block $A$. Friction exists between the blocks,whereas the ground on which the block $A$ is placed is taken to be smooth. $A$ horizontal force $F$,increasing linearly with time,begins to act on $B$. The acceleration $a_A$ and $a_B$ of blocks $A$ and $B$ respectively are plotted against $t$. The correctly plotted graph is

$A$ $0.5\, kg$ ball moving with a speed of $12\, m/s$ strikes a hard wall at an angle of $30^\circ$ with the wall. It is reflected with the same speed at the same angle. If the ball is in contact with the wall for $0.25\, s$,the average force acting on the wall is ........... $N$.

As shown in the figure,a block of mass $2 \ kg$ is placed on a rough inclined plane such that it just touches the spring. The block moves downwards. What will be the maximum compression of the spring in $cm$?

The masses of blocks $A$ and $B$ are $100 \, kg$ and $200 \, kg$ respectively. The coefficient of friction between $A$ and $B$ is $0.2$,and the coefficient of friction between $B$ and the ground is $0.3$. What force $F$ (in $N$) must be applied to block $B$ to make it move?

$A$ disc of mass $100 \,g$ slides down from rest on an inclined plane of $30^{\circ}$ and comes to rest after travelling a distance of $1 \,m$ along the horizontal plane. If the coefficient of friction is $0.2$ for both inclined and horizontal planes, then the work done by the frictional force over the whole journey, approximately, is (Acceleration due to gravity, $g=10 \,ms^{-2}$) (in $\,J$)