$A$ steel rod has a radius of $10 \,mm$ and a length of $1.0 \,m$. $A$ force stretches it along its length and produces a strain of $0.32 \%$. The Young's modulus of the steel is $2.0 \times 10^{11} \,N/m^2$. What is the magnitude of the force stretching the rod in $kN$?

$A$ block of weight $100 \ N$ is suspended by copper and steel wires of same cross-sectional area $0.5 \ cm^2$ and lengths $\sqrt{3} \ m$ and $1 \ m$,respectively. Their other ends are fixed on a ceiling as shown in the figure. The angles subtended by the copper and steel wires with the ceiling are $30^{\circ}$ and $60^{\circ}$,respectively. If the elongation in the copper wire is $\Delta \ell_C$ and the elongation in the steel wire is $\Delta \ell_S$,then the ratio $\frac{\Delta \ell_C}{\Delta \ell_S}$ is. . . . . .
[Young's modulus for copper and steel are $1 \times 10^{11} \ N/m^2$ and $2 \times 10^{11} \ N/m^2$ respectively]

$A$ wooden wheel of radius $R$ is made of two semicircular parts. The two parts are held together by a metal ring of cross-sectional area $S$ and length $L$. $L$ is slightly less than $2\pi R$. To fit the ring on the wheel,the ring is heated by a temperature $\Delta T$. If the coefficient of linear expansion of the metal is $\alpha$ and its Young's modulus is $Y$,the force that one part of the wheel exerts on the other is:

An iron rod of length $2\, m$ and cross-sectional area of $50\, mm^2$ is stretched by $0.5\, mm$ when a mass of $250\, kg$ is hung from its lower end. The Young's modulus of the iron rod is:

Two metallic wires $P$ and $Q$ have the same volume and are made up of the same material. If their areas of cross-section are in the ratio $4:1$ and a force $F_1$ is applied to $P$,an extension of $\Delta l$ is produced. The force required to produce the same extension in $Q$ is $F_2$. The value of $\frac{F_1}{F_2}$ is . . . . . . .

The lengths of four wires $A, B, C$ and $D$ made of the same material are $1 \,m, 2 \,m, 3 \,m$ and $4 \,m$ respectively. The radii of the wires $A, B, C$ and $D$ are $0.2 \,mm, 0.4 \,mm, 0.6 \,mm$ and $0.8 \,mm$ respectively. For the same applied tension, the elongation is more in which wire?