If the following input signal is sent through | vedclass

Name: Exam Paper Generator | JEE NEET Paper Generator | Vedclass
Brand: Vedclass
Rating: 5 (35 reviews)

Question

(C) The circuit acts as a half-wave rectifier. When the input voltage is $+10 V$,the $P$-terminal of the diode is at a higher potential than the $N$-t

Vedclass · Accepted Answer

Vedclass · Answer

(C) The circuit acts as a half-wave rectifier. When the input voltage is $+10 V$,the $P$-terminal of the diode is at a higher potential than the $N$-terminal,making the diode forward-biased. In this state,the diode conducts,and the output voltage across $R_L$ is $+10 V$. When the input voltage is $-10 V$,the $P$-terminal is at a lower potential than the $N$-terminal,making the diode reverse-biased. In this state,the diode does not conduct,and the output voltage across $R_L$ is $0 V$. Therefore,the output signal is a pulse that remains at $+10 V$ when the input is $+10 V$ and drops to $0 V$ when the input is $-10 V$.

If the following input signal is sent through a $PN$-junction diode,then the output signal across $R_L$ will be:

Similar Questions

In a half-wave rectifier using a $PN$ junction diode,the input voltage has an amplitude of $25 \ V$ and a frequency of $50 \ Hz$. No filter is used,and the load resistance is $1000 \ \Omega$. The forward resistance of the diode is $10 \ \Omega$. The ripple factor is:

The $P-N$ junction diode acts as a rectifier in the circuit shown below. An alternating current source is connected to the circuit. The current in the resistor $(R)$ can be observed as follows. Which of the following is correct?

In a full-wave rectifier, if the input frequency is $50 \ Hz$, then the output ripple frequency is ......... $Hz$.

In a full-wave rectifier circuit without a filter,the output current is

The process by which $ac$ is converted into $dc$ is known as

Vedclass Test Series

Exam Paper Generator

Online Exam Module