$A$ body of mass $10 \ kg$ is attached to a wire of $0.3 \ m$ length. The breaking stress is $4.8 \times 10^7 \ N \ m^{-2}$. The area of cross-section of the wire is $10^{-6} \ m^2$. The maximum angular velocity with which it can be rotated in a horizontal circle is

$A$ rod of length $1.05 \; m$ having negligible mass is supported at its ends by two wires of steel (wire $A$) and aluminium (wire $B$) of equal lengths as shown in Figure. The cross-sectional areas of wires $A$ and $B$ are $1.0 \; mm^{2}$ and $2.0 \; mm^{2}$ respectively. At what point along the rod should a mass $m$ be suspended in order to produce $(a)$ equal stresses and $(b)$ equal strains in both steel and aluminium wires?

Read the following two statements below carefully and state,with reasons,if it is true or false.
$(a)$ The Young's modulus of rubber is greater than that of steel;
$(b)$ The stretching of a coil is determined by its shear modulus.

What is buckling? What should be the shape of a rod for preventing buckling?

Two strips of metal are riveted together at their ends by four rivets,each of diameter $6.0\; mm$. What is the maximum tension that can be exerted by the riveted strip if the shearing stress on the rivet is not to exceed $6.9 \times 10^{7}\; Pa$? Assume that each rivet is to carry one quarter of the load.

Two blocks of masses $1 \, kg$ and $2 \, kg$ are connected by a metal wire going over a smooth pulley as shown in the figure. The breaking stress of the metal is $2 \times 10^9 \, N/m^2$. What should be the minimum radius of the wire used if it is not to break? Take $g = 10 \, m/s^2$.