A ring of mass M and radius R sliding with a | vedclass

Name: Exam Paper Generator | JEE NEET Paper Generator | Vedclass
Brand: Vedclass
Rating: 5 (35 reviews)

Question

(D) When the ring enters the rough surface,it is purely sliding forward with velocity $v_0$ and has no initial angular velocity $(\omega = 0)$.$1$. Si

Vedclass · Accepted Answer

All of the above.

Vedclass · Answer

(D) When the ring enters the rough surface,it is purely sliding forward with velocity $v_0$ and has no initial angular velocity $(\omega = 0)$.$1$. Since the ring is sliding,the kinetic friction force $f = \mu N = \mu Mg$ acts on it,which is the limiting friction.$2$. The friction force acts at the point of contact in a direction opposite to the velocity of the point of contact,which is opposite to the direction of motion of the ring.$3$. The friction force $f$ creates a torque $	au = f 	imes R$ about the centre of mass. Since the friction acts at the bottom point towards the left,the torque is in the clockwise direction,which causes an angular acceleration $\alpha$ in the clockwise sense.Therefore,all the given statements are correct.

$A$ ring of mass $M$ and radius $R$ sliding with a velocity $v_0$ suddenly enters a rough surface where the coefficient of friction is $\mu$,as shown in the figure. Choose the correct statement$(s)$.

Similar Questions

$A$ rod of mass $m$ and length $l$ is hinged at one end to a horizontal floor and stands vertically. If it is allowed to fall,the velocity with which its upper end strikes the floor is:

$A$ uniform rod of mass $M$ is hinged at its upper end. $A$ particle of mass $m$ moving horizontally strikes the rod at its mid-point elastically. If the particle comes to rest after the collision,find the value of $M/m$.

The portion $AB$ of the wedge shown in the figure is rough and $BC$ is smooth. $A$ solid cylinder rolls without slipping from $A$ to $B$. The ratio of translational kinetic energy to rotational kinetic energy,when the cylinder reaches point $C$,is:

$A$ rod hinged at one end is released from the horizontal position as shown in the figure. When it becomes vertical,its lower half separates without exerting any reaction at the breaking point. Then the maximum angle '$\theta$' made by the hinged upper half with the vertical is ......... $^o$.

$A$ uniform rod of length $2L$ has one end on a horizontal floor. It is inclined at an angle $\alpha$ to the horizontal floor. It falls without slipping,rotating about the point of contact. Its angular velocity when it hits the horizontal floor will be:

Vedclass Test Series

Exam Paper Generator

Online Exam Module