$A$ metallic square wire loop of side $10\, cm$ and resistance $1\,\Omega$ is moved with a constant velocity $v_0$ in a uniform magnetic field of induction $B = 2\, T$ as shown in the figure. The magnetic field is perpendicular into the plane of the loop. The loop is connected to a network of resistors each of value $3\,\Omega$. The resistance of the lead wires $OS$ and $PQ$ are negligible. What should be the speed of the loop so as to have a steady current of $1\, mA$ in it? Give the direction of current in the loop.

$A$ circular coil of $500$ turns of wire has an enclosed area of $0.1\,m^2$ per turn. It is kept perpendicular to a magnetic field of induction $0.2\,T$ and rotated by $180^o$ about a diameter perpendicular to the field in $0.1\,s$. How much charge will pass when the coil is connected to a galvanometer with a combined resistance of $50\,\Omega$?

$A$ long straight wire is parallel to one edge of a rectangular loop as shown in the figure. If the current in the long wire varies with time as $I = I_0 e^{-t/\tau}$,what will be the induced $emf$ in the loop?

The current $I$ in an $A.C.$ circuit inductance coil varies with time according to the graph given below. Which one of the following graphs gives the variation of voltage with time?

$A$ short-circuited coil is placed in a time-varying magnetic field. Electrical power is dissipated due to the current induced in the coil. If the number of turns were to be quadrupled and the wire radius halved,the electrical power dissipated would be

$A$ circular insulated copper wire loop is twisted to form two loops of area $A$ and $2A$ as shown in the figure. At the point of crossing,the wires remain electrically insulated from each other. The entire loop lies in the plane of the paper. $A$ uniform magnetic field $\vec{B}$ points into the plane of the paper. At $t=0$,the loop starts rotating about the common diameter as an axis with a constant angular velocity $\omega$ in the magnetic field. Which of the following options is/are correct?
[$A$] The rate of change of the flux is maximum when the plane of the loops is perpendicular to the plane of the paper.
[$B$] The net emf induced due to both the loops is proportional to $\cos \omega t$.
[$C$] The emf induced in the loop is proportional to the sum of the areas of the two loops.
[$D$] The amplitude of the maximum net emf induced due to both the loops is equal to the amplitude of maximum emf induced in the smaller loop alone.