Let L be the length and d be the diameter of | vedclass

Name: Exam Paper Generator | JEE NEET Paper Generator | Vedclass
Brand: Vedclass
Rating: 5 (35 reviews)

Question

(C) The extension $\Delta L$ of a wire is given by the formula $\Delta L = \frac{F \cdot L}{A \cdot Y}$, where $F$ is the tension, $L$ is the length,

Vedclass · Accepted Answer

$L = 50 \ cm, d = 0.05 \ mm$

Vedclass · Answer

(C) The extension $\Delta L$ of a wire is given by the formula $\Delta L = \frac{F \cdot L}{A \cdot Y}$, where $F$ is the tension, $L$ is the length, $A$ is the cross-sectional area, and $Y$ is Young's modulus.Since $A = \pi \cdot (d/2)^2 = \frac{\pi d^2}{4}$, we can write $\Delta L = \frac{4 F L}{\pi d^2 Y}$.Given that $F$ and $Y$ are constant for the same material and same tension, we have $\Delta L \propto \frac{L}{d^2}$.Calculating the ratio $\frac{L}{d^2}$ for each case:$A: \frac{200}{(0.5)^2} = \frac{200}{0.25} = 800$$B: \frac{300}{(1.0)^2} = \frac{300}{1} = 300$$C: \frac{50}{(0.05)^2} = \frac{50}{0.0025} = 20000$$D: \frac{100}{(0.2)^2} = \frac{100}{0.04} = 2500$Comparing these values, the ratio is maximum for option $C$.

Let $L$ be the length and $d$ be the diameter of the cross-section of a wire. Wires of the same material with different $L$ and $d$ are subjected to the same tension along the length of the wire. In which of the following cases will the extension of the wire be the maximum?

Similar Questions

If the ratio of diameters,lengths and Young's moduli of steel and brass wires shown in the figure are $p, q$ and $r$ respectively,then the corresponding ratio of increase in their lengths would be

Same tension is applied to the following four wires made of same material. The elongation is longest in

$A$ steel rod has a radius of $10 \,mm$ and a length of $1.0 \,m$. $A$ force stretches it along its length and produces a strain of $0.32 \%$. The Young's modulus of the steel is $2.0 \times 10^{11} \,N/m^2$. What is the magnitude of the force stretching the rod in $kN$?

$A$ wire of cross-sectional area $10^{-6} \, m^2$ is stretched such that its length increases by $0.1\%$. If the tension produced in the wire is $1000 \, N$, calculate the Young's modulus of the wire.

Two copper wires $A$ and $B$ of lengths in the ratio $1: 2$ and diameters in the ratio $3: 2$ are stretched by forces in the ratio $3: 1$. The ratio of the elastic potential energies stored per unit volume in the wires $A$ and $B$ is

Vedclass Test Series

Exam Paper Generator

Online Exam Module