The diameter of a brass rod is $4 \ mm$ and Young's modulus of brass is $9 \times 10^{10} \ N/m^2$. The force required to stretch it by $0.1\%$ of its original length is:

The ratio of the lengths of two wires of the same material is $1:2$ and the ratio of their radii is $1:\sqrt{2}$. If they are stretched by the same force,what is the ratio of the increase in their lengths?

The length of a metal wire is $L_1$ when the tension is $T_1$ and $L_2$ when the tension is $T_2$. The unstretched length of the wire is:

$A$ block of mass $2 \ kg$ is tied to one end of a $2 \ m$ long metal wire of $1.0 \ mm^2$ area of cross-section and rotated in a vertical circle such that the tension in the wire is zero at the highest point. If the maximum elongation in the wire is $2 \ mm$, the Young's modulus of the metal is (Acceleration due to gravity $= 10 \ ms^{-2}$)

$A$ wire of area of cross-section $10^{-6} \ m^2$ is increased in length by $0.1 \%$. The tension produced is $1000 \ N$. The Young's modulus of the wire is:

$A$ wooden wheel of radius $R$ is made of two semicircular parts (see figure). The two parts are held together by a ring made of a metal strip of cross-sectional area $S$ and length $L$. $L$ is slightly less than $2\pi R$. To fit the ring on the wheel,it is heated so that its temperature rises by $\Delta T$ and it just slips over the wheel. As it cools down to the surrounding temperature,it presses the semicircular parts together. If the coefficient of linear expansion of the metal is $\alpha$,and its Young's modulus is $Y$,the force that one part of the wheel applies on the other part is: