The length of a potentiometer wire is $L$. $A$ cell of e.m.f. $E$ is balanced at a length $\frac{L}{3}$ from the positive end of the wire. If the length of the wire is increased by $\frac{L}{2}$,at what distance will the same cell give a balance point?

$A$ $10\,m$ long potentiometer wire has a potential gradient of $0.0025\,V/cm$. Calculate the distance of the null point when the wire is connected to a $1.025\,V$ standard cell.

When a cell of e.m.f. $E_1$ is connected to a potentiometer wire,the balancing length is $\ell_1$. Another cell of e.m.f. $E_2$ $(E_1 > E_2)$ is connected such that the two cells oppose each other,and the balancing length is $\ell_2$. The ratio $E_1 : E_2$ is:

$A$ potentiometer circuit is set up as shown. The potential gradient across the potentiometer wire is $k \, V/cm$ and the ammeter present in the circuit reads $1.0 \, A$ when the two-way key is switched off. The balance points,when the key between the terminals $(i)$ $1$ and $2$ and $(ii)$ $1$ and $3$ is plugged in,are found to be at lengths $l_1$ and $l_2$ respectively. The magnitudes of the resistors $R$ and $X$ in ohms are equal to:

In the figure,the potentiometer wire of length $l = 100 \, cm$ and resistance $R = 9 \, \Omega$ is joined to a cell of emf $E_1 = 10 \, V$ and internal resistance $r_1 = 1 \, \Omega$. Another cell of emf $E_2 = 5 \, V$ and internal resistance $r_2 = 2 \, \Omega$ is connected as shown. The galvanometer $G$ will show no deflection when the length $AC$ is ............... $cm$.

For the measurement of potential difference,a potentiometer is preferred in comparison to a voltmeter because: