Two wires $A$ and $B$ are made of the same material having a ratio of lengths $\frac{L_A}{L_B} = \frac{1}{3}$ and their diameters ratio $\frac{d_A}{d_B} = 2$. If both the wires are stretched using the same force,what would be the ratio of their respective elongations?

$A$ block of weight $100 \ N$ is suspended by copper and steel wires of same cross-sectional area $0.5 \ cm^2$ and lengths $\sqrt{3} \ m$ and $1 \ m$,respectively. Their other ends are fixed on a ceiling as shown in the figure. The angles subtended by the copper and steel wires with the ceiling are $30^{\circ}$ and $60^{\circ}$,respectively. If the elongation in the copper wire is $\Delta \ell_C$ and the elongation in the steel wire is $\Delta \ell_S$,then the ratio $\frac{\Delta \ell_C}{\Delta \ell_S}$ is. . . . . .
[Young's modulus for copper and steel are $1 \times 10^{11} \ N/m^2$ and $2 \times 10^{11} \ N/m^2$ respectively]

$A$ wire of length $L$ and radius $r$ is rigidly fixed at one end. On stretching the other end of the wire with a force $F$,the increase in its length is $l$. If another wire of same material but of length $2L$ and radius $2r$ is stretched with a force of $2F$,the increase in its length will be

The lengths of four wires $A, B, C$ and $D$ made of the same material are $1 \,m, 2 \,m, 3 \,m$ and $4 \,m$ respectively. The radii of the wires $A, B, C$ and $D$ are $0.2 \,mm, 0.4 \,mm, 0.6 \,mm$ and $0.8 \,mm$ respectively. For the same applied tension, the elongation is more in which wire?

$A$ sphere of mass $2 \,kg$ and diameter $4.5 \,cm$ is attached to the lower end of a steel wire of $2 \,m$ length and area of cross-section $0.24 \times 10^{-6} \,m^2$. The wire is suspended from a $205 \,cm$ high ceiling of a room. When the system is made to oscillate as a simple pendulum, the sphere just grazes the floor at its lowest position. Find the velocity of the sphere at the lowest position. (Young's modulus of steel $= 2 \times 10^{11} \,Nm^{-2}$ and acceleration due to gravity $= 10 \,ms^{-2}$) (in $\,ms^{-1}$)

$A$ mild steel wire of length $1.0 \; m$ and cross-sectional area $0.50 \times 10^{-2} \; cm^{2}$ is stretched,well within its elastic limit,horizontally between two pillars. $A$ mass of $100 \; g$ is suspended from the mid-point of the wire. Calculate the depression at the midpoint.