Area of the cross-section of a wire is measured using a screw gauge. The pitch of the main scale is $0.5 \text{ mm}$. The circular scale has $100$ divisions and for one full rotation of the circular scale, the main scale shifts by two divisions. The measured readings are listed below.

Measurement condition	Main scale reading	Circular scale reading
Two arms of gauge touching each other without wire	$0$ division	$4$ division
Attempt-$1$: With wire	$4$ division	$20$ division
Attempt-$2$: With wire	$4$ division	$16$ division

What are the diameter and cross-sectional area of the wire measured using the screw gauge?

$10$ divisions on the main scale of a Vernier calliper coincide with $11$ divisions on the Vernier scale. If each division on the main scale is of $5$ units,the least count of the instrument is :

The length of a cylinder measured by a Vernier caliper is given by the following observations: $3.29 \, cm, 3.28 \, cm, 3.29 \, cm, 3.31 \, cm, 3.28 \, cm, 3.27 \, cm, 3.29 \, cm, 3.30 \, cm$. The most accurate length of the cylinder is ........ $cm$.

Length of $9 \ MSD$ of a vernier caliper are equal to $10 \ VSD$ and $1 \ MSD = 1 \ mm$. For measuring the length of a rod,the reading on the main scale is $6.4 \ cm$ and the $8^{th}$ division on the vernier scale is in line with a marking on the main scale. If there is no zero error,find the length of the rod: (in $cm$)

Consider a Vernier callipers in which each $1 \ cm$ on the main scale is divided into $8$ equal divisions and a screw gauge with $100$ divisions on its circular scale. In the Vernier callipers,$5$ divisions of the Vernier scale coincide with $4$ divisions on the main scale and in the screw gauge,one complete rotation of the circular scale moves it by two divisions on the linear scale. Then:
$(A)$ If the pitch of the screw gauge is twice the least count of the Vernier callipers,the least count of the screw gauge is $0.01 \ mm$.
$(B)$ If the pitch of the screw gauge is twice the least count of the Vernier callipers,the least count of the screw gauge is $0.005 \ mm$.
$(C)$ If the least count of the linear scale of the screw gauge is twice the least count of the Vernier callipers,the least count of the screw gauge is $0.01 \ mm$.
$(D)$ If the least count of the linear scale of the screw gauge is twice the least count of the Vernier callipers,the least count of the screw gauge is $0.005 \ mm$.

$A$ screw gauge gives the following readings when used to measure the diameter of a wire:
Main scale reading: $0 \, mm$
Circular scale reading: $52$ divisions
Given that $1 \, mm$ on the main scale corresponds to $100$ divisions on the circular scale. The diameter of the wire from the above data is ...... $cm$.