In a screw gauge,$5$ complete rotations of the screw cause it to move a linear distance of $0.25\, cm$. There are $100$ circular scale divisions. The thickness of a wire measured by this screw gauge gives a reading of $4$ main scale divisions and $30$ circular scale divisions. Assuming negligible zero error,the thickness of the wire is (in $, cm$)

Figure $1$ shows the configuration of the main scale and Vernier scale before measurement. Figure $2$ shows the configuration corresponding to the measurement of the diameter $D$ of a tube. The measured value of $D$ is (in $cm$)

In a Vernier Calipers,$10$ divisions of the Vernier scale are equal to $9$ divisions of the main scale. When both jaws of the Vernier calipers touch each other,the zero of the Vernier scale is shifted to the left of the zero of the main scale,and the $4^{\text{th}}$ Vernier scale division exactly coincides with a main scale division. One main scale division is equal to $1\,mm$. While measuring the diameter of a spherical body,the body is held between the two jaws. It is observed that the zero of the Vernier scale lies between $30$ and $31$ divisions of the main scale,and the $6^{\text{th}}$ Vernier scale division exactly coincides with a main scale division. The diameter of the spherical body is $.......\,cm$.

Given below are two statements: one is labelled as Assertion $(A)$ and the other is labelled as Reason $(R)$.
Assertion $(A)$: In a Vernier calliper, if a positive zero error exists, then while taking measurements, the reading taken will be more than the actual reading.
Reason $(R)$: The zero error in a Vernier calliper might have happened due to a manufacturing defect or due to rough handling.
In the light of the above statements, choose the correct answer from the options given below:

The smallest division on the main scale of a vernier callipers is $1 \ mm$,and $10$ vernier divisions coincide with $9$ main scale divisions. While measuring the diameter of a sphere,the zero mark of the vernier scale lies between $2.0 \ cm$ and $2.1 \ cm$ of the main scale,and the fifth division of the vernier scale coincides with a main scale division. The diameter of the sphere is:

The diameter of a spherical bob is measured using a vernier callipers. $9$ divisions of the main scale,in the vernier callipers,are equal to $10$ divisions of vernier scale. One main scale division is $1\, {mm}$. The main scale reading is $10\, {mm}$ and $8^{\text{th}}$ division of vernier scale was found to coincide exactly with one of the main scale division. If the given vernier callipers has positive zero error of $0.04\, {cm}$,then the radius of the bob is $...... \,\times 10^{-2} \,{cm}$.