Figure $1$ shows the configuration of the main scale and Vernier scale before measurement. Figure $2$ shows the configuration corresponding to the measurement of the diameter $D$ of a tube. The measured value of $D$ is (in $cm$)

In a vernier callipers,$10$ divisions of vernier scale coincide with $9$ divisions of main scale,the least count of which is $0.1\,cm$. If in the measurement of inner diameter of a cylinder,the zero of the vernier scale lies between $1.3\,cm$ and $1.4\,cm$ of the main scale and the $2^{nd}$ division of the vernier scale coincides with a main scale division,then the diameter will be .......... $cm$.

Given below are two statements:
Statement $I$: In a vernier callipers,one vernier scale division is always smaller than one main scale division.
Statement $II$: The vernier constant is given by one main scale division multiplied by the number of vernier scale division.
In the light of the above statements,choose the correct answer from the options given below.

While measuring the diameter of a wire using a screw gauge, the following readings were noted. The main scale reading is $1 \,mm$ and the circular scale reading is equal to $42$ divisions. The pitch of the screw gauge is $1 \,mm$ and it has $100$ divisions on the circular scale. The diameter of the wire is $\frac{x}{50} \,mm$. The value of $x$ is:

$A$ screw gauge has a least count of $0.01\, mm$ and there are $50$ divisions on its circular scale. The pitch of the screw gauge is $........\, mm$.

The vernier calliper used for measurement has a positive zero error of $0.3 \ mm$. While taking measurement for the internal diameter of a vessel,it was observed that the zero of the vernier scale lies between $9.5 \ cm$ and $9.6 \ cm$ of the main scale and the $6^{th}$ division of the vernier scale coincides with a main scale division. If the least count of the vernier calliper is $0.01 \ cm$,the correct value of the diameter will be: (in $cm$)