$A$ rod is fixed between two points at $20\,^oC$. The coefficient of linear expansion of the material of the rod is $1.1 \times 10^{-5}/\,^oC$ and Young's modulus is $1.2 \times 10^{11}\,N/m^2$. Find the stress developed in the rod if the temperature of the rod becomes $10\,^oC$.

One end of the steel rod is clamped to the roof and the other end is attached to a mass of $1000 \,kg$ as shown in the figure. The length of the rod is $50 \,cm$ and its cross-sectional area is $1000 \,mm^2$. The change in the length of the rod due to the weight of the mass is (Young's modulus of steel $= 2 \times 10^{11} \,Nm^{-2}$ and acceleration due to gravity $= 10 \,ms^{-2}$) (in $\,mm$)

In an experiment to determine the Young's modulus of a wire of length exactly $1\;m$,the extension in the length of the wire is measured as $0.4\;mm$ with an uncertainty of $\pm 0.02\;mm$ when a load of $1\;kg$ is applied. The diameter of the wire is measured as $0.4\;mm$ with an uncertainty of $\pm 0.01\;mm$. The error in the measurement of Young's modulus $(\Delta Y)$ is found to be $x \times 10^{10}\;N/m^2$. The value of $x$ is (Take $g = 10\;m/s^2$)

$A$ rigid massless rod of length $6L$ is suspended horizontally by means of two elastic rods $PQ$ and $RS$ as shown in the figure. Their area of cross-section,Young's modulus,and lengths are mentioned in the figure. Find the deflection of end $S$ in the equilibrium state. The free end of the rigid rod is pushed down by a constant force $F$. $A$ is the area of cross-section,$Y$ is Young's modulus of elasticity.

$A$ metallic rod $1 \, cm$ long with a square cross-section is heated through $1^{\circ} C$. If Young's modulus of elasticity of the metal is $E$ and the mean coefficient of linear expansion is $\alpha$ per degree Celsius,then the compressional force required to prevent the rod from expanding along its length is: (Neglect the change of cross-sectional area)

To break a wire of $1 \, m$ length, a minimum weight of $40 \, kg \, wt$ is required. Then, the wire of the same material with double the radius and $6 \, m$ length will require a breaking weight of ....... $kg \, wt$.