The force required to stretch a steel wire of $1\,cm^2$ cross-section to $1.1$ times its original length is $(Y = 2 \times 10^{11}\,N/m^2)$.

Two wires $A$ and $B$ of the same cross-section are connected end to end. When the same tension is applied to both wires,the elongation in wire $B$ is twice the elongation in wire $A$. If $L_A$ and $L_B$ are the initial lengths of the wires $A$ and $B$ respectively,then (Young's modulus of material of wire $A = 2 \times 10^{11} \ Nm^{-2}$ and Young's modulus of material of wire $B = 1.1 \times 10^{11} \ Nm^{-2}$):

To break a wire of $1 \, m$ length, a minimum weight of $40 \, kg \, wt$ is required. Then, the wire of the same material with double the radius and $6 \, m$ length will require a breaking weight of ....... $kg \, wt$.

Wires $A$ and $B$ are connected with blocks $P$ and $Q$ as shown. The ratio of lengths,radii,and Young's modulus of wires $A$ and $B$ are $r, 2r$,and $3r$ respectively ($r$ is a constant). Find the mass of block $P$ if the ratio of the increase in their corresponding lengths is $1/(6r^2)$. The mass of block $Q$ is $3M$.

When the temperature of a wire of length $L_0$ is increased by $T$,what is the energy density? The volume expansion coefficient of the wire is $\gamma$ and the Young's modulus is $Y$.

$A$ load of $1 \,kg$ weight is attached to one end of a steel wire of area of cross-section $3 \,mm^2$ and Young's modulus $10^{11} \,N/m^2$. The other end is suspended vertically from a hook on a wall, then the load is pulled horizontally and released. When the load passes through its lowest position, the fractional change in length is $(g = 10 \,m/s^2)$.